Air | water heat pumps
HPA-O 7 CS Premium
- Air-water heat pump installed outdoors for heating and cooling
- With energy efficient inverter technology for high flow temperatures even during cold winters
- Suitable for buildings set closely together thanks to low operating noise
- Can be combined with a solar thermal system
- Integral cooling function
- High energy efficiency class A++ even at a flow temperature of 55 °C
Questions about the productGet contact
Product detailsAPPLICATION: Inverter air source heat pump with output-dependent control, designed as a compact mono block appliance for outdoor installation. Can be used for heating and DHW operation; the AC version also provides efficient cooling via circuit reversal. Suitable for new build and modernisation projects due to high flow temperatures.
EQUIPMENT/CONVENIENCE: Optimised noise reduction due to encapsulated refrigerant circuit and acoustically isolated compressor. The wide gaps between the evaporator fins create low air resistance and, in combination with the modulating fan, result in a low sound power level. The combined enhanced vapour injection/enhanced saturated vapour injection cools the scroll compressor at low outside temperatures, enabling a higher heating output/flow temperature to be achieved. In combination with the ISG (additional accessory), the heat pump controller (required accessory) can be used to control the system via a home network or mobile device. With integral heat and electricity metering via refrigerant circuit data. An emergency/booster heater enables mono energetic operation. The refrigerant circuit is hermetically sealed, tested for tightness at the factory and filled with safety refrigerant R410A.
EFFICIENCY: The waste heat from the inverter is used to raise the return temperature. This increases the overall efficiency of the system. Demand-dependent and energy efficient defrosting through circuit reversal. The condensate pan is heated by the refrigerant circuit to enable efficient defrosting.
INSTALLATION: Integral anti-vibration mounts for direct connection to the heating system. Pivoting electrical connection panel for better accessibility. Quick access to the condensate pan via cleaning aperture at the rear. The metal casing is corrosion-protected and made from galvanised, powder coated sheet steel, with an alpine white stove enamel finish. The fan grille, recessed grips and cover are made from weatherproof and UV-resistant plastic in aluminium white.
Please ask your local power supply utility or a registered electrician to install appliances that are not fully wired, i.e. ready to plug in. The electrician should also be able to assist you with obtaining the agreement of the respective power supply utility required for the appliance installation.