Air-water heat pumps
HPA-O 4 CS Plus compact Set
-
![STIEBEL ELTRON Air-water heat pumps HPA-O 4 CS Plus compact Set]()
![STIEBEL ELTRON Air-water heat pumps HPA-O 4 CS Plus compact Set]()
![STIEBEL ELTRON Air-water heat pumps HPA-O 4 CS Plus compact Set]()
- Little space required
- Buffer cylinder not required if the minimum flow rate is sufficient
Questions about the product
Get contact![]()
![]()
![]()
Product details
SET COMPONENTS: Heat pump from the classic range and hydraulic and cylinder module HSBB 200 classic including DHW cylinder with internal indirect coil. With circulation pump, 3/2-way diverter valve, 12 litre expansion vessel for the heating system, safety valve and electric emergency/booster heater. The unit is controlled by the integral heat pump manager.APPLICATION: Inverter air | water heat pump with output-dependent control, designed as a compact mono block appliance for outdoor installation. Can be used for heating and DHW operation; also provides efficient cooling via circuit reversal. Ideally suited for use in new builds or buildings with a low system temperature. Sold in perfectly matched sets with compact indoor units for straightforward, space saving installation.
EQUIPMENT/CONVENIENCE: Optimum noise reduction due to encapsulated refrigerant circuit and acoustically isolated compressor. With integral heat and electricity metering via refrigerant circuit data.
EFFICIENCY: The waste heat from the inverter is used to raise the return temperature, thereby increasing the overall efficiency of the system. Demand-dependent and energy efficient defrosting by reversing the circuit.
INSTALLATION: Accessories for effective condensate drainage are available for both floorstanding or wall mounted installations. Integral anti-vibration mounts for direct connection to the heating system. Easy access to the electrical connection panel without having to open the appliance.
Installation Information:
Please ask your local power supply utility or a registered electrician to install appliances that are not fully wired, i.e. ready to plug in. The electrician should also be able to assist you with obtaining the agreement of the respective power supply utility required for the appliance installation.