back

Air-water heat pumps
HPA-O 3 CS Plus compact Set S

    • Little space required
    • Buffer cylinder not required if the minimum flow rate is sufficient

    Questions about the product

    Get contact

    Product details

    SET COMPONENTS: Heat pump and cylinder and hydraulic module including DHW cylinder with internal indirect coil. With circulation pump, 3/2-way diverter valve, 12 litre expansion vessel for the heating system, safety valve and electric emergency/booster heater. Control is via the integral heat pump manager.

    APPLICATION: Inverter air source heat pump with output-dependent control, designed as a mono block appliance for compact outdoor installation. Can be used for heating and DHW; also provides efficient cooling via circuit reversal. Ideally suited for use in new builds or buildings with a low system temperature. Sold in perfectly matched sets with compact indoor units for straightforward, space saving installation.

    EQUIPMENT/CONVENIENCE: Optimum noise reduction due to encapsulated refrigerant circuit and acoustically isolated compressor. With integral heat and electricity metering via refrigerant circuit data.

    EFFICIENCY: The waste heat from the inverter is used to raise the return temperature. This increases the overall efficiency of the system. Demand-dependent and energy efficient defrosting by reversing the circuit.

    INSTALLATION: Accessories for effective condensate drainage are available for both floorstanding or wall mounted installations. Integral anti-vibration mounts for direct connection to the heating system. Easy access to the electrical connection panel without having to open the appliance.



    ERP product datasheet

    Technical datasheet

    Product Number: 238992

    Show all

    Download as PDF

    Equipment datasheet

Installation Information:

Please ask your local power supply utility or a registered electrician to install appliances that are not fully wired, i.e. ready to plug in. The electrician should also be able to assist you with obtaining the agreement of the respective power supply utility required for the appliance installation.